M09416
®
Thermal Transfer Printer
2.7. Replacing Label Guide & Gap Sensor Assembly
1. Please refer to 3.1 for disassembling the lower cover and lower inner cover.
2. Disconnect all the hardness.
3. Turn the lower inner cover upside down.
4. Screws off 4 screws and remove the plastic laminate.
Screws
5. Screws off 2 screws to remove the white label guide rack fixing plate
6. Remove 2 screws from a gap sensor PCB then remove the gap sensor PCB.
Screws
Label Guide
Rack Fixing
Plate
7. Turn over the lower inner cover.
TTXLI
®
Screw
16
nate
Plastic Lami
Screws
Lower inner cover
Gap Sensor
PCB