Table of Contents
Advertisement
04/02 Rev. 2.15-01
Cleaning the feed roller
1. Switch unit off and pull off mains plug!< D>
2. Remove material.
3. Remove insertion plate by loosen two knurled screws below the plate.
4. Clean the accessable section of print roller with dust-free cloth and clean-
sing liquor only. Advance print roller by switching on the printer, close prin-
thead lever,press FEED key - the roller turns a quarter round.
5. Switch unit off and pull off mains plug!
Never use knives or objects with sharp edges for cleaning.
Cleaning of gap sensor
According to the materials applied, the light barrier is to be cleaned from ma-
terials residues and dust by means of compressed air.
With heavy contamination additional cleaning by using a dust-free cloth and
cleansing liquor is recommended.
Cleaning of material guiding parts
According to the materials applied any residues at material baffles is to be
cleaned regularly.
Contaminated surfaces influence the feed of material which will reduce the
print quality.
MANUAL
TTX 207 – Da Capo
Setup, Operation, Service, page 9
Advertisement
Table of Contents
