❶ Installati On; I Selecti Ng The Locati On - Zodiac ZS500 Instructions For Installation And Use Manual

❶ Installati on

1.1 I Selecti ng the locati on

• The device must be installed at a minimum distance from the pool's surrounding edge.
This distance is determined by the electrical standards which apply in the installati on country.
• Do not lift the appliance using the casing, handle it from the base.
• For outdoor installati on, provide free space around it (see § "1.2 I Hydraulic connecti ons").
• For indoor installati on, the device must be equipped with the plant room kit.
• Place the device on its anti -vibrati on studs (integrated under its base, height adjustable) on a stable, solid and level
surface,
• This surface must be able to bear the weight of the device (in parti cular in the case of installati on on a roof, a balcony
or any other support).
The device must not be installed:
• With the blowing towards a permanent or temporary obstacle (awning, brushwood, etc.) less than 5 metres away,
• Within range of water or mud jets, sprays or run-off (take the eff ect of the wind into account),
• Near a heat source or fl ammable gas,
• Near high frequency equipment,
• In a locati on where it would be subject to snow build-up,
• In a locati on where it might be fl ooded by the condensati on produced by the device when operati ng.
Tip: reduce any noise annoyance from your heat pump
• Do not install it under or towards a window.
• Do not ti lt it towards your neighbours.
• Install it in a clear space (the sound waves are refl ected on surfaces).
• Install an acousti c screen around the heat pump, respecti ng the distances.
• Install 50cm of fl exible PVC pipe at the heat pump water input and output (stops vibrati ons).
• Increase the fi ltrati on ti me by 50% and acti vate "Eco Silence" mode. The heat pump will run for longer
with less power, but much more quietly and with an improved COP (energy savings). Only use the "Eco
Silence" mode to maintain the desired temperature.
H0430700.E - EN - 2016-01
EN
3