❶ Installati On; I Selecti Ng The Locati On - Zodiac Z900 TD20 Instructions For Installation And Use Manual

❶ Installati on

1.1 I Selecti ng the locati on

• The device must be installed at a minimum distance from the pool's surrounding edge.
This distance is determined by the electrical standards which apply in the installati on country.
• Use the holes provided (Ø 40mm) when lift ing the device. A lift ing kit is available as an
accessory (see § "5.1 I Descripti on"»).
• Install the device outdoors; provide free space around it (see § "1.2 I Hydraulic connecti ons").
• Install the 6 anti -vibrati on studs under the base and place the device on a stable, solid and level surface.
Positi on of the anti -vibrati on studs as seen from under the device
• This surface must be able to bear the weight of the device (in parti cular in the case of installati on on a roof, a balcony
or any other support). We recommend that you install the device on a slab to channel the condensati on away.
The device must not be installed:
• With the blowing towards a permanent or temporary obstacle (awning, brushwood, etc.) less than 5 metres away,
• Within range of water or mud jets, sprays or run-off (take the eff ect of the wind into account),
• Near a heat source or fl ammable gas,
• Near high frequency equipment,
• In a locati on where it would be subject to snow build-up,
• In a locati on where it might be fl ooded by the condensati on produced by the device when operati ng.
Informati on: condensati on drainage
Cauti on, your device may evacuate several litres of water per day, caused by condensati on from the water
present in the air.
Tip: reduce any noise annoyance from your heat pump
• Do not install it under or towards a window.
• Do not ti lt it towards your neighbours.
• Install it in a clear space (the sound waves are refl ected on surfaces).
• Install an acousti c screen around the heat pump, respecti ng the distances.
• Install 50cm of fl exible PVC pipe at the heat pump water inlet and outlet (to stop the transmission of
vibrati ons).
Stud mounti ng order
EN
3