❷ Installati On; I Selecti Ng The Locati On - Zodiac Z200 M2 Installation And Use Instructions Manual

Table of Contents

Advertisement

❷ Installati on

2.1 I Selecti ng the locati on

• Do not lift the device by the body; use its base.
• The device must be installed at a minimum distance from the pool's surrounding edge.
This distance is determined by the electrical standards which apply in the installati on country.
Install the device outdoors; provide free space around it (see § "2.2 I Hydraulic connecti ons").
Place the device on its anti -vibrati on studs (integrated under its base) on a stable, solid and level surface,
This surface must be able to bear the weight of the device (in parti cular in the case of installati on on a roof, a balcony
or any other support).
The device may be secured to the ground using the holes in the base of the device or with rails (not supplied). A
drilling scale is available on the back of the packaging carton.
Top view of the device with dimensions for att achment to the ground
The device must not be installed:
In a locati on subject to high winds,
With the blowing towards a permanent or temporary obstacle (window, wall, hedge, awning, etc.) less than 3 metres
away,
Within range of water or mud jets, sprays or run-off (take the eff ect of the wind into account),
Near a heat source or fl ammable gas,
Near high frequency equipment,
In a locati on where it would be subject to snow build-up,
In a locati on where it might be fl ooded by the condensati on produced by the device when operati ng.
Tips: reduce any noise annoyance from your heat pump
Do not install it under or towards a window.
Do not ti lt it towards your neighbours.
Install it in a clear space (the sound waves are refl ected on surfaces).
Install an acousti c screen around the heat pump, respecti ng the distances.
Install the anti -vibrati on studs under the heat pump and replace them regularly.
Install 50cm of fl exible PVC pipe at the heat pump water input and output (stops vibrati ons).
H0548500.A - EN - 2015-11
: front
: rear
: connectors
EN
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z200 m3Pi2031Pi2021Z200 m4Pi2041Pi2051 ... Show all

Table of Contents