I Error Code Display - Zodiac ZS500 Instructions For Installation And Use Manual

4.2 I Error code display

Display
Error 01
Bad connecti on between the A1
and A2 boards
Communicati on
fault between the
regulati on board
Board power supply fault
and the display
board
Faulty boards
Machine's rear panel slots
Error 02
blocked
Overheati ng on the
electronic board
Venti lator operati ng incorrectly
Electrical network overvoltage
or interrupti on or drop in the
Error 03
network voltage
Automati c
Incorrect earthing
protecti on against
electrical network
instabiliti es
A1 board operati ng incorrectly
Error 05
Venti lator motor disconnected
Error on the
venti lator motor
Venti lator motor damaged
Machine's rear panel slots
Error 06
blocked
Compressor supply
overheati ng
Venti lator operati ng incorrectly
Electrical supply over or
undervoltage
Error 07
Compressor operati ng incorrectly
Compressor supply
A1 board operati ng incorrectly
overintensity
Incorrect connecti on of the
masses to the earth.
Error 08
Pressure fault in the low pressure
circuit (if problem persists aft er
Low pressure fault
resetti ng)
on cooling circuit
Exchanger clogged with dirt
Error 09
Insuffi cient water fl ow
Cooling circuit high
Air and water emulsion passed
pressure fault
into the device
Flow controller blocked
Error 10
Sensor is faulty or offl ine (J14
ST3 sensor fault
connector)
Defrost sensor
Error 11
Sensor is faulty or offl ine (J12
ST sensor fault air
connector)
intake sensor
H0430700.E - EN - 2016-01
Possible causes
connectors on the link cable between
the boards
Clean the rear panel If problem
persists, call an approved technician
network
correctly connected
connector. If problem persists, call an
approved technician
Clean the rear panel
If problem persists, call an approved
technician
voltage (maximum 240V ±10%)
correctly connected
Call an approved technician
that the pool fi lter is not clogged
Soluti ons
Check the RJ11 and RJ45
Check the boards' power supply
Replace the boards
Replace the venti lator motor
Check the quality of the electrical
Check that the eart cables are
Replace the A1 board
Check the venti lator motor
Replace the venti lator motor
Replace the venti lator motor
Check the electrical supply
Replace the compressor
Replace the A1 board
Check that the eart cables are
Clean the water exchanger
Increase fl ow using by-pass, check
Check the pool's hydraulic circuit
Check the fl ow controller
Reconnect or change the sensor
Reconnect or change the sensor
Resetti ng
Automati c (if fewer
than 4 faults per
hour) or press
Automati c
Automati c (if fewer
than 4 faults per
hour) or press
Automati c (if fewer
than 4 faults per
hour) or press
EN
Automati c (if fewer
than 4 faults per
hour) or press
Automati c (if fewer
than 4 faults per
hour) or press
Automati c (if fewer
than 4 faults per
hour) or press
Automati c (if fewer
than 4 faults per
hour) or press
Automati c (if fewer
than 4 faults per
hour) or press
Press
Press
13