Genie ZX-135/70 Service And Repair Manual page 106

Service and Repair Manual
Display Module
Screen or Menu
Machine Status With key switch on, press the
(plus)(minus) buttons at the same
time.
Unit of Measure
With key switch
and Language the enter button and turn key switch to
on position.
Release the enter button and press
(plus)(minus)(minus)(plus).
Overload Recovery
(software V3.07 and later)
Default Reset With key switch
the enter button and turn key switch to
on position.
Release the enter button and press
(minus)(minus)(previous)(previous)
94
Procedure
, press and hold
OFF
, press and hold
OFF
ZX-135/70
Description
Hydraulic pressure PSI
(English)
Hydraulic pressure kPa (metric) 0-31000 kPa
Primary boom to secondary
boom angle
Primary boom length
Secondary boom angle*
Secondary boom length
Jib bellcrank angle
DPF Regeneration Mode
(Auto / Force / Inhibit)
Metric/English (measurement
units)
Set engine
Clear Overload Recovery
Delete drive functions
Delete boom function speed
Delete lift function ramps
Delete all (Contact Genie
Product Support before using
this option)
Delete Faults
October 2016
Range or Selection
0-4500 PSI
+22° to +136°
=0', >0', >22
-3.5° to 76°
=0FT, >0 FT
-10° to +10°
*(referenced to chassis
tilt angle)
English, German,
French, Spanish,
Portuguese, Italian,
Dutch, and Swedish.
Deutz TD2011L04i
(DL04i)
Perkins 1104D-44T
(P1104)
YES/NO
A passcode is required
to clear the message
Delete faults will reset
active latching faults.
Delete faults will not
clear fault history.
Part No. 1268558