Genie ZX-135/70 Service And Repair Manual page 111

October 2016
Screen or Menu
Sensor Calibration
(before software version
4.01)
Part No. 1268558
Procedure
With key switch , press and hold
OFF
the enter button and turn key switch to
on position.
Release the enter button and press
(plus)(enter)(enter)(plus).
Description
Set unit X-axis to gravity
Set unit Y-axis to gravity
Set platform level to gravity (YES/NO)
Platform level sensor millivolts/degree
Delete axles angle sensors calibration?
(YES/NO)
YES: Axle angle fully retracted (YES/NO)
YES: Axle angle fully extended (YES/NO)
Delete all steer sensors calibrations?
(YES/NO)
Delete blue end blue side steer sensor (FL)
calibration? (YES/NO)
Delete yellow end blue side steer sensor (RL)
calibration? (YES/NO)
Delete blue end yellow side steer sensor (FR)
calibration? (YES/NO)
Delete yellow end yellow side steer sensor
(RR) calibration? (YES/NO)
Delete secondary boom angle sensor
calibration? (YES/NO)
secondary boom angle to gravity -3.5°
secondary boom angle to gravity 20°
secondary boom angle to gravity 35°
secondary boom angle to gravity 50°
secondary boom angle to gravity 65°
secondary boom angle to gravity 76°
Delete primary boom angle sensor
calibration? (YES/NO)
primary boom angle to gravity 0°
primary boom angle to gravity -50°
primary boom angle to gravity -20°
primary boom angle to gravity 10°
primary boom angle to gravity 40°
primary boom angle to gravity 70°
Delete level angle sensor calibration?
(YES/NO)
jib level calibration deg to gravity 60°
jib level calibration deg to gravity 34°
jib level calibration deg to gravity 8°
jib level calibration deg to gravity -18°
jib level calibration deg to gravity -44°
jib level calibration deg to gravity -70°
ZX-135/70
Service and Repair Manual
Display Module
Range or
Selection
Use +/- buttons
to adjust
99