Genie ZX-135/70 Service And Repair Manual page 36

Service and Repair Manual
Platform Controls
Drive functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button on the ground
control panel while turning the key switch to
platform controls. Hold the enter button for
approximately 5 seconds.
3 Press the minus button twice, then press the
enter button twice.
4 Use the scroll button to scroll through the
menu until DELETE DRIVE JOYSTICK
DEFAULTS is displayed.
5 Press the plus button to select YES, then
press the enter button.
6 Do not start the engine.
7 Locate the drive/steer joystick.
8 Move the drive/steer joystick full stroke in the
forward direction and hold for 5 seconds, then
return to the center or neutral position.
9 Move the drive/steer joystick full stroke in the
reverse direction and hold for 5 seconds, then
return to the center or neutral position.
Result: The alarm at the ground controls should
sound for a successful calibration.
24
Steer functions:
1 Turn the key switch to the off position.
2 Press and hold the enter button on the ground
control panel while turning the key switch to
platform controls. Hold the enter button for
approximately 5 seconds.
3 Press the minus button twice, then press the
enter button twice.
4 Use the scroll button to scroll through the
menu until DELETE STEER JOYSTICK
DEFAULTS is displayed.
5 Press the plus button to select YES, then
press the enter button.
6 Do not start the engine.
7 Locate the drive/steer joystick.
8 Move the drive/steer joystick or thumb rocker
switch (if equipped) full stroke in the left
direction and hold for 5 seconds, then return to
the center or neutral position.
9 Move the drive/steer joystick or thumb rocker
switch (if equipped) full stroke in the right
direction and hold for 5 seconds, then return to
the center or neutral position.
Result: The alarm at the ground controls
should sound for a successful calibration.
ZX-135/70
October 2016
Part No. 1268558