Injector Sleeves - Perkins 2800 Workshop Manual

3

Injector sleeves

To remove and to fit
Special requirements
Description
Injector installer/removal
Vacuum pump
Tube
Bottle
To remove
1 Remove the rocker shaft assemblies, Operation 3-2.
2 Remove the electronic injector units, Operation 3-12.
3 Mark the bridge pieces and make a note of their position to assist during assembly, then remove the bridge
pieces.
4 Fit the puller stud from the special tool, GE50021, into the injector sleeve as shown (A). Fit the bridge, thrust
bearing, washer and nut, from the special tool, over the stud as shown. Tighten the nut (A1) of the special tool
until the sleeve is drawn from the cylinder head. Remove the special tool from the sleeve.
5 Remove the 'O' ring seals from the injector sleeve. Check the condition of the injector sleeve and renew if
necessary.
6 Repeat steps 1 to 5 for the injector sleeves which remain.
54
Special tools
Part number
GE50021 Brush
GE50028 Brush
GE50030
Brush
GE50029
Operation 3-14
Description
Workshop Manual, TSD3450E, Issue 1
2800
Part number
GE50022
GE50023
GE50024