Perkins 2800 Workshop Manual page 58

3
2800
To fit
1 Fit the two pilot tools, GE50015, to the rear end of the camshaft. Ensure that the camshaft and camshaft
bearings have been cleaned thoroughly. Apply clean engine oil to the lobes and journals of the camshaft. Apply
a thin coat of clean engine oil to the camshaft bearings.
2 Fit the camshaft guide (E1), GE50017, to the gear case cover, but do not tighten the bolts fully.
3 Insert the alignment sleeve (E2), GE50016, through the camshaft guide (E1) and into the camshaft bearings
to align the camshaft guide correctly. Tighten the bolts which retain the camshaft guide, GE50017, on the gear
case. Remove the alignment sleeve; the sleeve should move freely from the bore of the camshaft guide,
GE50017.
4 Fit the cradle tool (F1), GE50018, at the position shown (F).
Note: Rotate the camshaft in both directions during installation to prevent binding.
5 Use a suitable strap and hoist to support the camshaft. Insert the camshaft through the guide and into the
cylinder head. Move the camshaft into the head as far as the strap and hoist will allow.
6 Remove the strap and hoist. Rotate the camshaft during installation. Do not allow the end of the camshaft
to drop during removal of the hoist as the bearings can be damaged. Use the lifting hooks, GE50025, to
support the camshaft during installation.
7 Remove the pilot tools and push the camshaft fully into its bore.
8 Inspect the seal (G3) and renew if necessary. Fit the rear cover (G1), complete with seal (G3).
Continued
48 Workshop Manual, TSD3450E, Issue 1