Perkins 2800 Workshop Manual page 77

5
2800
To fit
Note: Before the new seal and wear sleeve are installed, read carefully the special instruction which is supplied
with each seal and wear sleeve.
1 Clean and the wear sleeve inside diameter and crankshaft outside diameter with quick cure primer,
CV60892. Apply some retaining compound, CV60893, to the crankshaft outside diameter before the wear
sleeve is installed on the crankshaft. Do not allow any quick cure primer or retaining compound to touch the
lip of the seal.
2 Use the bolts (C3), GE50009, to install the guide, GE50008, on the crankshaft.
Notes:
l The seal and the wear sleeve must be installed in a dry condition.
l Ensure that the seal is fitted with the part number and the crankshaft rotation arrows toward the outside.
Caution: The front and rear seals and wear sleeves have different spiral grooves. The seal will not function if
it is installed at the wrong end of the engine.
3 Fit the wear sleeve and seal (C4) as a unit onto the locator, GE50008.
4 Fit the installer (C2), GE50012, onto the locator.
5 Apply clean engine oil to the face of the nut (C1), GE50014, and to its contact area on the installer, GE50012.
6 Fit the nut to the locator and tighten the nut until the inside surface of the installer is in contact with the
locator.
7 Remove all of the tools from the crankshaft.
8 Fit the vibration damper, Operation 5-4.
Workshop Manual, TSD3450E, Issue 1 67