Crankshaft Vibration Damper; Operation 5-4 To Remove And To Fit - Perkins 2800 Workshop Manual

5
2800

Crankshaft vibration damper

To remove and to fit Operation 5-4
To remove
1 Remove the fan guards.
2 Slacken the tension on the fan drive belts, then remove the belts from the crankshaft pulley (A1).
3 Attach a strap and a suitable lifting device to the vibration damper (A2). Remove the six bolts and washers
which retain the vibration damper and the adapter (A3) to the crankshaft.
4 Remove damper and adapter. The weight of the vibration damper is approximately 25 kg (55 lb).
Note: The dash marks at the front of the damper assembly must be in alignment with each other. If the dash
marks are not in alignment, renew the damper assembly.
70 Workshop Manual, TSD3450E, Issue 1