4
Configuring The Meter
4.5 SELECTING A DISPLAY COLOR
Note
Selecting Display Color is not active unless your meter is a Version "B".
To select a display color, follow these steps:
Press the MENU button until the meter shows COLR.
1.
Press the ∂TARE button. The meter shows one of the following:
2.
Press the ßNT/GRS button to scroll between available choices.
3.
4.
Press the MENU button to store your choice. The meter momentarily shows
STRD , followed by the next menu S1.CF (Setpoint 1 Configuration). Or you can
press the RESET button to abort and go back to the RD.CF menu.
4.6 USING SETPOINT 1 CONFIGURATION
Note
Setpoint 1 Configuration S1.CF is not active unless your meter has dual relay output
capabilities. The LED's will display whether the S1.CF is active or not. You may use
Setpoint 1 Configuration S1.CF for the following:
30
Refer to Table 6-1 for a summary list of menu configuration.
GRN
•
RED
•
AMBR
•
Refer to Table 6-1 for a summary list of menu configuration.
•
To set the setpoint's active band above or below your chosen value
•
To select whether the setpoint operation is latched or unlatched
•
Assigning setpoint values to the net or gross reading
COLR
S1.CF