Table of Contents
Advertisement
2
About The Meter
METER BUTTONS
SETPTS Button
In the Run Mode, this button will sequentially recall the previous setpoint settings. As
necessary, use the
the SETPTS button to store new values.
Unless you press the SETPTS,
meter will scroll to setpoint 2 and then to the Run Mode.
Note
/NT/GRS Button
In the Run Mode, this button will toggle between net/gross readings or peak readings
depending upon setup.
In the Configuration Mode, press this button to change the value of the flashing digit
shown on the display and/or toggle between menu choices, such as R.1=R or R.1=N on
RD.CF menu. When configuring your setpoint values, press the
advance the flashing digit's value from 0 to 9 by 1.
/TARE Button
In the Run Mode press the
In the Configuration Mode, press the this button to scroll to the next digit.
6
/NT/GRS and
If the dual relay option is not installed or if L.3=1 is displayed on the LK.CF
menu, pressing the SETPTS button will display the meter's firmware version.
/TARE button to tare your reading (zeroing).
/TARE buttons to alter these settings, then press
/TARE, or
/NT/GRS button within 20 seconds, the
/NT/GRS button to
Hide quick links:
Advertisement
Table of Contents
