Connecting To Your Pc; Method 1 - Dhcp Router Setup (Display Models Only); Method 2 - Direct To Pc Setup With An Rj45 Ethernet Cable (Display And Non-Display Models) - Omega iServer 2 Series User Manual

5 Connecting to your PC

To connect your iServer 2 unit to your PC, follow the instructions for one of the
listed below.
A successful setup will result in the user accessing the webserver login page. Refer to the applicable
connection method below:
5.1 Method 1 – DHCP Router Setup (Display Models only)
Connect your iServer 2 directly to a DHCP-enabled router using an RJ45 cable. On the display
model, the assigned IP address will appear on the lower right of the device display. Open a web
browser and navigate to the assigned IP address to access the web UI.
Important:
5.2 Method 2 – Direct to PC Setup with an RJ45 Ethernet Cable (Display and Non-Display
Models)
Connect your iServer 2 directly to your PC using an RJ45 Ethernet cable. Identify the MAC Address
assigned to your iServer 2 by checking the label on the backside of the device.
Open a web browser and enter the following URL to access
the web UI:
http://is2-omegaXXXX.local
(the XXXX should be replaced by the last 4 digits of the
iServer unit MAC address)
Figure 13: iServer 2 login page
For non-display models, the user will need to check the router's client IP table to
connect via DHCP or connect using Method 2 or 3.
three setup methods
Figure 14: iServer 2 label showing unique
MAC address
13 | M 5 7 9 1