Table of Contents
Advertisement
8. OPERATION
8-1
PREPARATION FOR IMAGING
(1) Connect the equipment as shown in Fig.7-1 before starting operating of the
camera.
(2) Switch the camera's power switch to ON.
After turning the power switch on, wait approximately 10 minutes for the
temperature to stabilize; this completes preparation for imaging.
8-2
IMAGING
The camera works with following setting after power is switched ON.
CCD output mode
Scan mode
Exposure time setting
Contrast enhancement gain
Digital data output bit count
The camera mode and parameters can be changed by command from the host computer,
which transmitted via the CameraLink interface.
8-3
END OF IMAGING
(1) End imaging or transmission of image data with the control software when
imaging is finished.
(2) Turn off the power to the camera and peripheral equipment.
Single output
Normal readout
Normal setting
0
12
HAMAMATSU PHOTONICS K.K.
C9300-201 Ver.1.2
11
Advertisement
Table of Contents
