Scanning Active Time; Flash On Time - Datalogic PD9330 Product Reference Manual

Enter/Exit Programming Mode

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON
state once the state is entered. The range for this setting is from 1 to 255
seconds in 1-second increments. See
description of this feature.
$CSNET05(CR)
Scanning Active Time = 5 seconds

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in
100 millisecond increments. See
mation on setting this feature.
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
72
10 = Flash is ON for 1 Second
DEFAULT
page 277 in "References" for further
$CSNET03(CR)
Scanning Active Time = 3 seconds
DEFAULT
$CSNET08(CR)
Scanning Active Time = 8 seconds
page 278 in "References" for detailed infor-
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
Appendix D, Keypad
meric characters in
senting your desired character(s). End by scanning
the ENTER/EXIT bar code twice.
~
CANCEL
PowerScan™ PD9330/PBT9300/PM9300
repre-