Code 11 Set Length 2 - Datalogic PD9330 Product Reference Manual

Enter/Exit Programming Mode

Code 11 Set Length 2

This feature specifies one of the bar code lengths for
trol. Length 2 is the maximum label length if in
second fixed length if in
check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to
ignore this length (only one fixed length).
Table 17
instructions on setting this feature.
Table 17. Code 11 Length 2 Setting Examples
STEP ACTION
Desired Setting (pad with
1
leading zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 11 LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
$CC1.2
Select Code 11 Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
156
Fixed Length
provides examples for setting Length 2. See
EXAMPLES
00 (Ignore This
Length)
'0' and '0'
50 = Length 2 is 50 Characters
DEFAULT
Variable Length
Mode. Length includes the bar code's
07 Characters 15 Characters
'0' and '7' '1' and '5'
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
dix D, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code
again.
~
CANCEL
PowerScan™ PD9330/PBT9300/PM9300
Code 11 Length Con-
Mode, or the
page 267 for detailed
50 Characters
'5' and 0'
Appen-