Linking The Reader; Link Datalogic Rf Devices To Base; Linking To A Bluetooth Adapter In Serial Port Profile (Slave) Mode; Linking To A Bluetooth Adapter In Serial Port Profile (Master) Mode - Datalogic PD9330 Product Reference Manual

Linking the Reader

Link Datalogic RF Devices to Base

For RF devices, before configuring the interface it is necessary to link the
handheld with the base.
To link the handheld and the base, press the trigger to wake up the hand-
held and mount it into the base. If the reader was previously linked to
another base, you must first press and hold the button on the base (>5 sec-
onds), then scan the

Linking to a Bluetooth Adapter in Serial Port Profile (Slave) Mode

1. Install any drivers provided with the Bluetooth adapter.
2. Scan the
3. Use the host computer's Bluetooth manager to "Discover new devices"
4. Use an RS-232 terminal program to see incoming data on the port des-

Linking to a Bluetooth Adapter in Serial Port Profile (Master) Mode

1. Ensure the PC or terminal can network with Bluetooth devices and that
2. Ensure that a COM port is assigned under Services in the Bluetooth
3. Create a Link label that contains the address of the PC Bluetooth
4. Scan the link label you created in step 3.
Product Reference Guide
Unlink
Enable RF Link to Server
to the host computer.
and select "Datalogic Scanner." If you receive an error message, it may
be necessary to disable security on the device.
ignated by the computer's Bluetooth manager.
it is powered on.
setup menu.
adapter.
The link label is a Code 128 function 3 label with the following format: 

<FN3 char>LnkB<12 character Bluetooth address>
The Bluetooth address can be found under "Properties" within the Bluetooth
setup menu.
bar code before re-linking to the new base.
Unlink
label below to make the scanner visible
Enable RF Link to Server
Linking the Reader
19