Global Prefix/Suffix (Header/Terminator) - Datalogic PD9330 Product Reference Manual

Enter/Exit Programming Mode

Global Prefix/Suffix (Header/Terminator)

This option sets up to 20 characters each from the set of ASCII characters or
any hex value from 00 to FF. The characters may be added as a prefix (in a
position before the bar code data, also called a header) and/or as a suffix (in
a position following the bar code data, also called a terminator). See
page 269
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the "Set Global
Prefix" or "Set Global Suffix," bar code followed by the digits (in hex) from
the Alphanumeric characters in
desired character(s). If less than the expected string of 20 characters are
selected, scan the ENTER/EXIT bar code to terminate the string. Exit pro-
gramming mode by scanning the ENTER/EXIT bar code twice.
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
50
for more detailed instructions on setting this feature.
No Global Prefix
DEFAULT
Global Suffix = 0x0D (CR)
Appendix D Keypad
$CLFPR
Set Global Prefix
~
CANCEL
PowerScan™ PD9330/PBT9300/PM9300
representing your