Lower Case; Set F1 Label; Set F2 Label - Datalogic PD9330 Product Reference Manual

Enter/Exit Programming Mode

Lower Case

This function enables/disables the capability to use the SHIFT key to switch
to Lower Case (alphanumeric) mode. When enabled, the indication in the
upper right corner of display is 'ab'.
$CPWSA00\r
Disable Lower Case

Set F1 Label

This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSB
Set F1 label

Set F2 Label

This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSC
Set F2 label
248
$CPWSA01\r
SET FUNCTION KEY LABELS
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
pad. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code twice.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
pad. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code twice.
PowerScan™ PD9330/PBT9300/PM9300
DEFAULT
Enable Lower Case
Appendix D, Key-
Appendix D, Key-