Cbx Electrical Connections - Datalogic Matrix 120 Reference Manual

CBX ELECTRICAL CONNECTIONS

4 CBX ELECTRICAL CONNECTIONS
All Matrix 120 models can be connected to a CBX connection box through the CAB-1011
accessory cable. This accessory cable terminates in an M12 17-pin connector on the Matrix
120 side and in a 25-pin male D-sub connector on the CBX side.
CAUTION: Do not use CAB-DSxx-S accessory cables with Matrix 120.
We recommend making system connections through one of the CBX connection boxes since
they offer the advantages of easy connection, easy device replacement, opto-isolated inputs
(External Trigger and Input 2) and outputs (Outputs 1 and 2), and filtered reference signals.
NOTE: If you require direct wiring to the reader the connections are
indicated in Appendix A.
The table below gives the pinout of the CBX100/500 terminal block connectors. Use this
pinout when the Matrix 120 reader is connected by means of the CBX100/500:
Vdc Power Supply Input Voltage +
GND Power Supply Input Voltage -
Earth Protection Earth Ground
Power Source – External Trigger
+V
I1A External Trigger A (polarity insensitive)
I1B External Trigger B (polarity insensitive)
Power Reference – External Trigger
-V
Power Source – Inputs
+V
I2A Input 2 A (polarity insensitive)
I2B Input 2 B (polarity insensitive)
Power Reference – Inputs
-V
+V Power Source - Outputs
-V Power Reference - Outputs
O1+ Output 1 + opto-isolated and polarity sensitive
O1- Output 1 - opto-isolated and polarity sensitive
O2+ Output 2 + opto-isolated and polarity sensitive
O2- Output 2 - opto-isolated and polarity sensitive
Shield Cable shield connected to chassis and 17-pin connector shell
* Do not leave floating, see par. 4.2.2 for connection details.
CBX100/500 Terminal Block Connectors
Input Power
Inputs
Outputs
Auxiliary Interface
Matrix 120 has no Auxiliary Interface
ID-NET
Matrix 120 has no ID-NET Interface
Main Interface
RS232
TX
RX
-
-
SGND
RS422 Full-Duplex
TX+
*RX+
TX-
*RX-
SGND
4
47