Datalogic Matrix 120 Reference Manual page 19

RAPID CONFIGURATION
Setup
1. Enter the Setup function by pressing and holding
the X-PRESS push button until the Setup LED is
on.
2. Release the button to enter the Setup function.
The Setup LED will blink until the procedure is
completed.
The Setup procedure ends when the Image
Acquisition parameters are successfully saved in
the reader memory, the Setup LED will stop
blinking and Matrix 120 emits 3 high pitched beeps.
If the calibration cannot be reached after a timeout
of about 5 (five) seconds Matrix 120 will exit without
saving the parameters to memory, the Setup LED
will stop blinking and in this case Matrix 120 emits a
long low pitched beep.
Learn
3. Enter the Learn function by pressing and holding
the X-PRESS push button until the Learn LED is
on.
4. Release the button to enter the Learn function.
The Learn LED will blink until the procedure is
completed.
The Learn procedure ends when the Image
Processing and Decoding parameters for a single
code are successfully saved in the reader
memory, the Green Spot is activated, the Learn
LED will stop blinking, and Matrix 120 emits 3 high
1
pitched beeps .
If the autolearning cannot be reached after a
timeout of about 3 (three) minutes Matrix 120 will
exit without saving the parameters to memory, the
Learn LED will stop blinking and in this case Matrix
120 emits a long low pitched beep.
NOTE: The Grade A Barcode Test Chart cannot be used to set the Code
128 symbology (even though the reader successfully reads the code). Use
the application specific code if you need to set this symbology.
NOTE: When using X-PRESS or the BM150 menu to perform the Auto-learn,
only a single code can be configured (successive Learns will substitute the
current code). To configure multiple codes, use the DL.CODE Auto-learn
procedure.
1
The Learn procedure will not recognize the following symbologies: Postal Codes, Pharmacode, MSI, Standard 2 of 5,
Matrix 2 of 5.
Figure 8 – X-PRESS Interface: Setup
Function
Figure 9 – X-PRESS Interface: Learn
Function
1
7