Software Configuration; Dl.code System Requirements; Reader Configuration - Datalogic Matrix 120 Reference Manual

SOFTWARE CONFIGURATION

7 SOFTWARE CONFIGURATION
Software configuration of your Matrix 120 for static reading or simple code reading
applications can be accomplished by the Rapid Configuration procedure using the X-PRESS
HMI (which requires no external configuration program). This procedure is described in
chapter 1 Steps 3-4.
For the majority of applications however you will use DL.CODE, connecting to the reader
through the on-board Ethernet interface. See chapter 1 Steps 5-6.

7.1 DL.CODE SYSTEM REQUIREMENTS

To install and run DL.CODE you should have a Laptop or PC that meets or exceeds the
following:

2.00 GHz or faster microprocessor

Windows: XP, 7, 8, or 10

1 GB RAM

2 GB hard disk for 64-bit machines; 1 GB hard disk for 32-bit machines

100 Base-T Ethernet

One 19" or larger monitor (optimized for 1280x1024 resolution)

7.2 READER CONFIGURATION

For an example of Matrix device configuration see the example in chapter 1 Steps 5-6.
NOTE: Especially for lengthy configurations, it is always good practice to
periodically save the configuration to permanent memory (Save on Device)
to avoid losing the configuration in Temporary Memory. You must give a
name to the new configuration or overwrite an existing one (except for Default
which cannot be modified).
When all the configuration parameters are set correctly and saved to the device, you can
perform a Backup to File and/or to an External storage device (BM100, etc.). See par. 7.5.
NOTE: An improvement in the Matrix N Family readers allows them to
contain several configurations or jobs in permanent memory.
This means that in addition to your application configuration(s), the Default
configuration is always present on the reader and in fact it is not modifiable
and cannot be deleted.
7
91