Battery Pack Removal And Replacement - Anritsu S412E Maintenance Manual

Chapter 6 — Battery Information and Replacement
6-4

Battery Pack Removal and Replacement

This section provides instructions for the removal and replacing the S412E battery pack.
Many of the procedures in this section are generic, and apply to many similar instruments. Photos
Note
and illustrations used are representative and may show instruments other than the S412E.
1. Locate the Battery Access Door, as shown in
Battery Door
Figure 6-1. Battery Access Door Location
2. Place a finger in the battery access door notch and push the door down towards the bottom of the
instrument.
3. Remove the Battery Access Door. The top will pop out a bit and then pull it up out of the access
enclosure.
S412E MM
6-4 Battery Pack Removal and Replacement
Figure 6-1.
PN: 10580-00324 Rev. N 6-3