Drive Positions; Removing A 3.5-Inch Device - HP ProDesk 400 G2 Small Form Factor Maintenance And Service Manual

Drive positions

1 Slim optical drive bay
2 3.5-inch internal hard drive bay
3 3.5-inch drive bay for optional drives (media card reader shown)
4 2.5-inch internal hard drive bay
NOTE: The drive configuration on your computer may be different than the drive
configuration shown above.
To verify the type and size of the storage devices installed in the computer, run Computer Setup.

Removing a 3.5-inch device

CAUTION:
computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
34 Chapter 4 Removal and replacement procedures: Small Form Factor
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
(Front bezel on page
(Preparation for disassembly on page
20).
21).
19).