Speaker - HP ProDesk 400 G2 Small Form Factor Maintenance And Service Manual

Speaker

The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
5. Lift the metal clip (1) that secures the speaker cable, and then disconnect the speaker wire from the
white system board connector labeled SPKR (2).
6. From the outside, front of the chassis, remove the two Torx screws that secure the speaker to the
chassis.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 21).
20).
19).
Speaker 53