Removing A 2.5-Inch Hard Drive; Installing A 2.5-Inch Hard Drive - HP ProDesk 400 G2 Small Form Factor Maintenance And Service Manual

Removing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the drive cage to its upright position.
4. Disconnect the power cable and data cable from the back of the hard drive.
5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops and
pull it down and out of the drive bay (2).

Installing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. If the computer is on a stand, remove the computer from the stand.
3. Remove the access panel
(Preparation for disassembly on page
(Access panel on page 20).
(Preparation for disassembly on page
(Access panel on page 20).
19).
19).
Drives 43