Toyota Camry Hybrid AHV40 Manual page 427

BE-166
JTRANSMITTER CODE REGISTRATION PROCEDURE
The garage door opener contains an EEPROM in which the maximum of 3 types of transmitter recognition
codes can be registered. A transmitter code is registered into the EEPROM of the garage door opener
according to the following steps.
A: Press the button for registering transmitter codes continuously until the indicator light flashes slowly.
B: While keeping the garage door opener's button pressed, place the transmitter for while you wish to
register the code within about 25 mm (1 in.) of the garage door opener and press the transmitter's button.
C: After the flashing of the indicator light changes from slow to quick flashing, the registration of the
transmitter code has been completed. Then, release your fingers from the buttons of the garage door
opener and the transmitter.
D: To register the code of another transmitter, repeat the operation starting with step A. To register a new
code to the button that already has a code registered to it, select the button to which you wish to register
the new code and start the operation starting with step A.
CAUTION
The garage door or the gate could operate unintentionally while registering a transmitter code.
Therefore, make sure that there are no people near the garage door or the gate before carrying out this
operation.
NOTE: D Before performing a transmitter code registration, stop the THS II.
D The transmitter code of a garage door opener manufactured before 1982 cannot be registered in
this system.
For details of procedures of transmitter code registration, see the 2007 Camry Hybrid Vehicle Repair Manual
(Pub. No. RM02H0U) to register the codes correctly.
BODY ELECTRICAL - GARAGE DOOR OPENER