Toyota Camry Hybrid AHV40 Manual page 151

CH-50
2) Brake Pedal Stroke Sensor
This sensor, which contains a contact type variable resistor, detects the extent of the brake pedal stroke
and transmits it to the skid control ECU.
Brake Pedal
Stroke Sensor
Voltage
Service Tip
D To install a brake pedal stroke sensor, which is available as a service part, perform as follows:
- The sensor lever is secured with a pin to "0" stroke. (Do not detach the pin until the
installation has been completed.)
- In this state, install the sensor on the brake pedal (in the OFF state) on the vehicle.
- After completing the installation, firmly press the brake pedal once to break off the pin that
is securing the sensor in place.
- Make sure the broken pin does not remain in the sensor lever.
D After replacing the brake pedal stroke sensor, initialization of brake pedal stroke sensor must
be required on the skid control ECU side.
D For the actual procedure, refer to the 2007 Camry Hybrid Vehicle Repair Manual (Pub. No.
RM02H0U).
CHASSIS - BRAKE
A
A
5
SKS2
1
0
-15 _
0
Sensor Lever Rotational Angle
Sensor Shaft
Lever
A - A Cross Section
SKS1
60_
Return Spring
Contacts
02HCH16Y
255CH164