Toyota Camry Hybrid AHV40 Manual page 422

SLIDING ROOF SYSTEM
JDESCRIPTION
D Sliding roof system is optional equipment.
D This system uses a single glass panel to perform tilt-up-down and open-and-close operations.
D The sliding roof ECU uses 2 type Hall ICs to detect the position of the sliding roof. Sliding roof ECU and
the 2 Hall ICs are integrated into the sliding roof motor assembly.
" A
System Diagram
Overhead Console
Combination Meter
Meter ECU
Warning Message Display
Vehicle Speed Signal
Service Tip
The memory is not cleared if battery terminals are disconnected. However, initialization is necessary
after the sliding roof motor assembly is replaced. Perform the initialization as follows:
D Keep pressing the TILT UP or SLIDE CLOSE switch until the initialization completely. This will
enable the sliding roof ECU to start initializing and perform the tilt up, tilt down, open, and close
operations of the sliding roof in sequence.
- Keep the switch pressed for 1 second after the tilt-up operation is completed.
- The sliding roof ECU performs the tilt down, open, and close operations.
- The initialization process ends when the close operation is completed.
Keep the tilt-up or slide close switch pressed during initialization. If the tilt up or close switch is
released during initialization, the system will not be able to complete the initialization. If this occurs,
the aforementioned steps must be performed again.
For details, see the 2007 Camry Hybrid Vehicle Repair Manual (Pub. No. RM02H0U).
BODY ELECTRICAL - SLIDING ROOF SYSTEM
Tilt Switch
Slide Control
Switch
CAN
(CAN No.1 Bus)
Sliding Roof Motor Assembly
Sliding Roof Motor
Sliding
Roof ECU
Local
Communication
Main Body ECU
Key OFF Operation Signal
BE-161
Hall IC1
Hall IC2
02HBE76TE