Toyota Camry Hybrid AHV40 Manual page 284

METER
JCOMBINATION METER
1. General
D An optitron display type combination meter is used which realizes excellent visibility through the use of
smoke acrylic in the protective panel, and bright LEDs (Light Emitting Diodes) that have high contrast
to illuminate the indicator and the dial.
D A multi-information display has been provided on the speedometer, in order to display the energy monitor,
cruise information, eco drive level, and any warning messages.
D An analog type fuel expense meter is used.
D A meter ECU and buzzer are enclosed in the combination meter. This ECU maintains communication with
other ECUs through the CAN (Controller Area Network).
D An eco drive level display is used, which changes the meter ring luminance and the multi-information
display in 4 levels, in accordance with the fuel consumption conditions.
D Illumination control, which turns on the combination meter illumination at different time intervals when
the power source is switched to IG-ON and READY, has been provided.
D A step-motor type movement is used to actuate the indicators of the speedometer, the fuel gauge, the
engine coolant temperature gauge.
Service Tip
If the LEDs malfunction, the entire combination meter assembly must be replaced. Refer to the 2007
Camry Hybrid Vehicle Repair Manual (Pub. No. RM02H0U).
BODY ELECTRICAL - METER
Fuel Expense Meter
U.S.A. Model
Multi-information Display
BE-23
02HBE09Y