Main Board Jumper Settings - Vecow MTC-4021 User Manual

21.5” fanless multi-touch computer, 6 gbe lan with 4 poe+, 2 sim, 4 usb, intel core i7/i5/i3 processor (broadwell-u)

Table of Contents

2.4 Main Board Jumper Settings

2.4.1 Front View of MTC-4021 Main Board with Jumper Location

The figure below is the top view of the MTC-4021 main board which is the

main board used in the MTC-4021 Series system. It shows the location of the

jumpers.

JP5

JP8

JP7

You may configure your card to match the needs of your application by setting

jumpers. A jumper is a metal bridge used to close an electric circuit. It consists

of two metal pins and a small metal clip (often protected by a plastic cover) that

slides over the pins to connect them. To "close" a jumper, you connect the pins

with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will

have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1

and 2, or 2 and 3.

JP6

JP10

JP11

GETTING TO KNOW YOUR MTC-4021

JP2

JP1

JP3

JP4

JP9

Table of Contents