Remote Monitor Ecom-R - Ecom EN2 Operating Instructions Manual

2. Remote monitor ecom-R

(possible data transfer distance approx. 10 m)
Connection with ecom-EN2
(the ecom-R is only connectable with one ecom-EN2)
Program connection:
-switch on ecom-EN2 (only one instrument with Bluetooth near
the ecom-R )
-choose at the ecom-EN2 in menu „Adjustments/Internal/
Bluetooth" the „ enhanced Protocol"
-switch on ecom-R (hold the red key approx. 1 s).
-hold the red key (approx. 5 s) until „Unpair:" appears
-switch on ecom-R (programming will be done automatically)
-if there is no connection (READY does not appear at right bottom of
the display), switch ecom-R off and on again
Operating
READY = Connection exists
CALIB = EN2 in calibration phase
WAIT = Searching for connection
ecom-EN2
ecom-EN2 must have Bluetooth option!
Battery voltage
Change functions
Start printout
CO switch-off
Choose display
Change display
Switch on/off ecom-R
(hold approx. 1 s)
Change display:
Choose line
Adjust line
Store adjustment
Break off adjustment
Page 7