How To Control The Unit - ACME CP-21TC User Manual

Sound
Press the MENU button up to when the
button, Use DOWN and UP button to select the
Once select, press ENTER button to setup or automatically exit menu mode without any
change after one minute. To go back to the functions without any change press the MENU
button
Blackout mode
Press the MENU button up to when the
button, Use DOWN and UP button to select the
Once select, press ENTER button to setup or automatically exit menu mode without any
change after one minute. To go back to the functions without any change press the MENU
button
Manual setting color
Press the MENU button up to when the
button, and use DOWN and UP button to select
(strobe), press ENTER button to confirm and use DOWN and UP button to adjust the value,
once select press ENTER button to setup or automatically exit menu mode without any
change after one minute. To go back to the last function without any change press the
MENU button.
White Balance
Press the MENU button up to when the
button, and use DOWN and UP button to select
button to confirm and use DOWN and UP button to adjust the value between 125 and 255,
once select press ENTER button to setup or automatically exit menu mode without any
change after one minute. To go back to the last function without any change press the
MENU button.
LED display
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select
is shown on the display. Pressing ENTER
(sound on) or (sound off).
is shown on the display. Pressing ENTER
(blackout) or (normal).
is shown on the display. Pressing ENTER
or ... or
,
is shown on the display. Pressing ENTER
, or , press ENTER
is shown on the display. Pressing ENTER
9-
always on) or
ENTER button to setup or exit menu mode without any change after one minute. Back to the
functions without any change press MENU button again.
Display Inverse
Press MENU button until
select (display normal) or
Back to the functions without any change press MENU button.
Temperature Test
Press the MENU button up to when the
button and the display will show the temperature of the unit. To go back to the functions
press the MENU button again.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.

4. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show "CP21" on the
display and move all the motors to their 'home' position. After that the unit will be ready to
receive DMX signal or run the built in programs.
(display
(display off 20 seconds after exit menu) mode. Once select, press
is blinking on the display. Use DOWN and UP button to
(display inverse), press ENTER button to setup.
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
10-