Toshiba PORTEGE S100 Maintenance Manual page 298

4 Replacement Procedure
4.29.2 Replacing the 14.1-inch SXGA+ TMD Fluorescent Lamp
CAUTION: When replacing the fluorescent lamp, wear finger covers or gloves to avoid
Disassembling the 14.1-inch SXGA+ TMD Fluorescent Lamp
To disassemble the 14.1-inch SXGA+ TMD fluorescent lamp, follow the steps below and
refer to Figure 4-53 to 4-63.
Peeling off the tapes and insulation sheets
1. Place the LCD module face down on a flat table that has no alien substance on it.
Make sure there is no dust on the desk to avoid scratching the surface of the LCD
module. Place a protection sheet (such as soft cloth) on the surface.
2. In the order (1), (2), (3), (4) shown in Figure 4-53, remove the tape for fixing the FL
cable, bezel tape1, bezel tape2 and fixing tape for insulation sheet. (Do not remove
the insulation sheet side tape.)
4-80
Downloaded from LpManual.com Manuals
contaminating or damaging the LCD panel. Be careful not to let dust or
other foreign substance into the module.
4.29 Fluorescent Lamp
PORTEGE S100 Maintenance Manual (960-508)