Toshiba PORTEGE S100 Maintenance Manual page 269

4.21 System board/DC-IN jack
5. Disconnect the HDD cable from the connector CN1850 on the system board.
Installing the System board/DC-IN jack
To install the system board/DC-IN jack, follow the steps below and refer to Figure 4-28 to 4-
30.
1. Connect the HDD cable to the connector CN1850 on the system board.
2. Connect the DC-IN jack cable to the connector CN8800 on the system board.
3. Install the DC-IN jack into the slot.
4. Install the system board from the left side and secure it with the following screw.
• M2×4B
5. Turn over the computer and connect the RTC battery cable and MDC cable to the
connector CN9990 and CN3001 on the system board.
PORTEGE S100 Maintenance Manual (960-508)
Downloaded from LpManual.com Manuals
CN1850
Figure 4-30 Removing the HDD cable
FLAT HEAD screw
4 Replacement Procedures
HDD cable
×1
4-51