Option Board Connector; Operator Interface Module Connector; Figure 2.7 - Typical Terminal Strip Connections; Rs-232 Communication Port - Reliance electric GV3000/SE Installation Manual

1 2 3
RS-232
CONNECTIONS

2.4.3 RS-232 Communication Port

2.4.4 Option Board Connector

2.4.5 Operator Interface Module Connector

2-10
4 5 6 7 8 9 10 11 12 13 14 15
ENCODER ANALOG ANALOG
CONNECTIONS OUTPUT
REFERENCE

Figure 2.7 - Typical Terminal Strip Connections

The Regulator board contains a 9-pin D-shell RS-232 communication port (J8). This
port provides RS-232 communication between the GV3000/SE drive and a personal
computer running the Control and Configuration (CS3000) software. See figure 2.4.
Refer to instruction manual D2-3348, for more information about the CS3000
software.
The flat-ribbon cable connector (J3) on the left side of the Regulator board is a
parallel bus connection port that provides a means of attaching optional boards
such as the DeviceNet Option board, the RMI board, or the AutoMax Network
Option board, or similar boards to the GV3000/SE drive. See figure 2.4. The option
board is mounted below the Regulator board inside the drive. Refer to the appropriate
board instruction for more information. Refer to section 2.5 of this manual for more
information on optional drive kits.
The flat-ribbon connector J7 provides a means of attaching the optional Operator
Interface Module (OIM). The OIM is available for use as a remote keypad for the
GV3000/SE drive.
16 20
17 18 19 21 22 23 24 25 26 27 28 29 30 31
CONFIGURABLE
Factory Installed
SPEED
DIGITAL INPUTS
(ISOLATED 24 VDC)
GV3000/SE 230 VAC 30-100 HP Drive, Hardware Reference Version 6.04
SNUBBER STATUS
BRAKING RELAYS