Reliance electric GV3000/SE Installation Manual page 63

Terminal
Number
18
Digital Input 7
(Default - Ramp 1/Ramp 2)
Wiring the Regulator Board Terminal Strip
Table 7.8 – Wiring Signal and Control I/O to the Terminal Strip (Continued)
Description
Wiring an Additional Ramp Input
Digital input 7 is control function programmable through
parameter P.007. The following parameters must be set:
P.000: Control Source
P.001: Accel Time 1 (Ramp 1)
P.002: Decel Time 1 (Ramp 1)
P.006: Second Menu Password
P.007: Terminal Strip Digital Inputs Configure (Selects and
P.008: Terminal Strip Speed Reference Source (Analog,
P.017: Accel Time 2 (Ramp 2)
P.018: Decel Time 2 (Ramp 2)
Note that based on the settings of parameters P.000, P.007, P.008,
and r.030 if an RMI board is used, the following
parameters can affect digital input 7.
P.023: MOP Accel/Decel Time
P.024: MOP Reset Configuration
P.031 to P.038: Preset Speeds 1-8
Refer to the GV3000/SE Software Start-Up and Reference manual
for additional information.
Terminal 18 On = Ramp 2
Diagram shows factory setting.
Parameters/Wiring Connections
assigns a control function to digital inputs 6 to 8).
Motor Operated Potentiometer (MOP), or Preset
Speeds)
16
RAMP 1
RAMP 2
18
7-13