6.3.2
Switching to standby
How to switch to standby?
1. Press Standby to switch the projector to standby.
Switching to Standby. When the projector is running and you want to go to standby, press the standby key for
2 seconds until the message 'Saving data, please wait' is displayed. Do not press any longer on the standby
key otherwise the projector will restart.
6.3.3
Switching off
How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.
6.3.4
Temperature error DMD
Overview
When the temperature of one of the DMD is too low or too high the projector will be switched automatically to standby. Before
switching to standby, the following message appears for 3 seconds on the screen : 'DMD out of operating temperature range.
Automatic shutdown is activated.'.
A '-t' appears on the LED display to indicate the user that the projector is switched to standby due to DMD temperature problems.
Operating temperature range of the DMD : +10 C and +40 C.
ERROR
DMD out of operating
temperature
range
Automatic shutdown is
activated
Menu 6-1
6.4 Quick Set Up Adjustments
Overview
•
Quick Language Change
•
Quick Lens Adjustment
•
Quick On Screen Color change
6.4.1
Quick Language Change
What can be done?
Only if different on screen languages are available, these can be changed in quick way by following the next procedure.
How to change
1. Press ENTER to start up the adjustment mode.
2. Press the cursor key ↑ or ↓ to highlight Service. (menu 6-2)
When password protected, your password will be asked. (more explanation about access by password can be found in Chapter
'Start up the Adjustment mode'.
3. Press ENTER to display the Service mode menu.
R5976445 BARCO GALAXY 15042003
6. Getting Started
29