Table of Contents
Advertisement
5.5 Input Source Connections
5.5.1
Input Facilities
Overview input facilities
Image 5-3
Input Facilities
Input number
1
2
3
5.5.2
Inputs via RCVDS05
Overview
When using a RCVDS05, the input configuration must be as follows:
slot 1
slot 2
slot 3
slot 4
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module has to be
connected to slot 1 of the projector. To switch the projector in the 5-cable mode see 'Input slots' in the chapter Installation mode.
5.5.3
Input 1 & 2
Input 1 & 2 specifications ?
•
Input 1& 2 have 5 BNC input terminals for 5 cable input and a DVI plug for DVI input.
•
Within the installation mode it is possible to setup the input for 5 cable or DVI.
•
Input 1 has also an DVI output for loop through to a second projector.
•
Composite video and super video signals can be connected on Input 1 when an optional decoder is installed.
•
Input 2 has no decoder so composite video and super video signals can not be connected.
R5976445 BARCO GALAXY 15042003
Type of input
5 cable input or DVI input and DVI output
5 cable input or DVI input
Left/Right Phasing module
RGB/Component
Video
not used
not used
5. Connections
23
Advertisement
Table of Contents
