Table of Contents
Advertisement
6.6.2
Displaying and Programming addresses
Displaying the Projector Address on the Screen.
1. Press Address key (recessed key on the RCU) with a pencil.
The projector's address will be displayed in a 'Text box'
To continue using the RCU with that specific address, it is necessary to enter the same address with the
digit buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example : if the
Address key displays projector address 003, then press "3" digit button on the RCU to set the RCU's address
to match the projector's address. Do not press 003 digits. This will address the remote control to '0' and
control all projectors in the room. If the address is not entered within 5 seconds, the RCU returns to its default
address (zero address) and control all projectors in the room.
How to Program an Address into the RCU?
1. Press the Address key (recessed key on the RCU) with a pencil.
2. Enter the address with the digit buttons within 5 seconds after pushing the address key.
Note: That address can be any digit between 0 and 9.
6.7 Controlling the Projector
Input Selection
Key in the corresponding slot number with the digit keys on the RCU. The selected source will be displayed.
Picture Controls
In Mono Mode, during the picture control adjustments, a text box with a bar scale, icon and function name of the control, e.g. 'bright-
ness...' appears on the screen (only if text is ON). See example screen. The length of the bar scale and the value of the numeric
indication indicate the current memorized setting for this source. The bar scale changes as the control stick on the RCU is pressed
or the + or - buttons on the local keypad.
In Stereo Mode an rudimentary barscale will appear.
Brightness
Contrast
Color
Tint
Sharpness
Phase
The Pause Key
When the Pause key is pressed, the image projection is stopped, a black screen will be displayed and the projector remains with full
power for immediate restart. The display on front of the projector will show a "P".
R5976445 BARCO GALAXY 15042003
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
A correct 'contrast' setting is important for good image reproduction. Adjust the contrast to the level
you prefer, according to room lighting conditions.
Use the + button for a higher contrast.
Use the - button for lower contrast.
Color saturation is only active for Video and S-Video. Adjust the color intensity of the picture.
Use the + button for richer colors.
Use the - button for lighter colors.
Tint is only active for Video and S-Video when using the NTSC 4.43 or NTSC 3.58 system.
Use the + button
Use the - button.
Use the + button for a sharper picture.
Use the - button for a softer picture.
Use the arrow buttons to adjust the phase.
6. Getting Started
33
Advertisement
Table of Contents
