Switching To Standby; Switching Off - Barco GALAXY R9040310 Owner's Manual

5. Connections
Lamp run time indication while running
When the total run time of the lamp is 30 hours less then 1000 or 1500 (depending on the lamp type), the following warning message
will be displayed for 1 minute. This warning message will be repeated every 30 minutes. Press EXIT to remove the message before
the minute is over.
When the total run time of the lamp is 1000 or 1500 (depending on the lamp type) hours or more, the following warning message,
with the exact run time is displayed on the screen.
Image 5-2
Lamp run time is 1000 or 1500 (depending on the lamp type) hours. Operating the lamp longer than 1000 hours may damage the
projector. Please replace the lamp.
When ENTER is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1000 or 1500 (depending on the lamp type) hours max. Do not use it longer.
Always replace with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Using a lamp for more than 1000 or 1500 (depending on the lamp type) hours is dangerous as the lamp could
explode.
Lamp Light Output Indication
When starting up and the center lumens measurement is lower than 50 % of its initial value, the lamp light output warning will be
displayed. Press ENTER to continue. The message will not be repeated during operation.
WARNING
Lamp run time is X hours
The light output of the lamp
is less
than 50% of its initial value.
It is advisable to replace the
lamp
before damage occurs.
<ENTER> to confirm
Menu 5-1
When the 'Constant Light Output' (CLO) options is installed, the light output message will appear on the screen when the light output
is reduced with 33% from its initial value.
This message will be repeated every hour.

5.3 Switching to standby

How to switch to standby?
1. Press Standby to switch the projector to standby.

5.4 Switching off

How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.
22 R5976445 BARCO GALAXY 15042003