Table of Contents
Advertisement
5. Connections
5.6 Communication Connections
Overview
•
RS232 (RS422) Connection
•
Communication with peripherals
•
Trigger output
5.6.1
RS232 (RS422) Connection
Application
1.
Remote control :
-
easy adjustment of projector via an IBM PC (or compatible) or MAC connection.
-
allow storage of multiple projector configurations and set ups.
-
wide range of control possibilities.
-
address range from 0 to 255.
2.
data communications : sending data to the projector or copying the data from the projector to a hard memory device (hard disc,
floppy, etc.).
Set up of the Baud Rate for communication with a computer.
see Baud rate Setting, page 78.
5.6.2
Communication with peripherals
What is possible with an RCVDS05 connected.
•
Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS's are linked via the expansion module.
•
Serial communication with the projector.
•
Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
•
The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED
on the rear.
For more information about the use of the RCVDS05, consult the owner's manual of the RCVDS05.
What is possible with an VS05 connected.
The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to
the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier. Order number : R9827890
For more information about the use of the VS05, consult the VS05 owner's manual.
Connecting an IR Remote Receiver to the projector.
This infrared receiver unit makes it possible to control the projector from another room. There is a communication line cable between
the IR receiver and the projector or the RCVDS. The control information from the RCU can now be sent to the IR Remote Receiver.
The IR Remote Receiver displays the selected source on a 7-segment display.
Connecting a Rugged Remote to the projector.
The Rugged Remote Control allows following functions:
•
Remote mode : sends actions to and reads information from the projector.
•
Lamp read mode : reads information stored in the lamp information module.
The following types of Rugged Remote Control are available:
•
wireless (order number R9840171)
•
wired to CTRL3 (order number R9840170)
For more information about the use of this remote control, consult the user manual R5976251.
5.6.3
Trigger output
Purpose
This trigger output can deliver a 5 V output voltage to trigger an external device (max. 10 mA). This voltage is available when the
projector is on.
26
R5976445 BARCO GALAXY 15042003
Advertisement
Table of Contents
