2Access Control List - Barco GALAXY R9040310 Owner's Manual

Get access to the controller module
1. Power down the projector and disconnect the power cord from the wall outlet.
2. Loosen the indicate screws of the input box. (image 10-1)
3. Pull out the input box by both handlers.
4. When looking inside the box, the controller module with the switches is situated in the middle of the box. (image 10-2)
5. Change the position of S2.
Image 10-1
Access password switch
How to change the password ?
1. Push the cursor key ↑ or ↓ to highlight Change Password. (menu 10-6)
2. Press ENTER to display the Change Password menu. (menu 10-7)
Note: Only possible when Owner.
The old passwords are displayed.
3. Push the cursor key ↑ or ↓ to highlight the password which must be changed.
4. Press ENTER to select.
Enter the new password with the numeric keys of the RCU or local keypad.
5. Select the next password or press ENTER to save the changes.
Press EXIT to return without saving the new passwords.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return.
Menu 10-6
10.4.2 Access Control List
What is possible?
In the access control list the owner can set up the access possibilities for the user and the guest.
R5976445 BARCO GALAXY 15042003
CHANGE PASSWORD
Enter new password
OWNER 0000
USER 0000
GUEST 0000
ACCESS CONTROL LIST
Select with ↑ or ↓
then <ENTER>
Reprogram with ↓,↑,← or →
or numeric keys
<ENTER> to confirm
<EXIT> to return.
Menu 10-7
Image 10-2
10. Service Mode
75