Ricoh SP 320SFN User Manual page 274

10. Troubleshooting
Message
ADF Orig. Misfeed
Open ADF Cover
and remove paper.
Available: IDCard
Copy A4 or 8 1/2 x
11
Busy
Cannot Copy This
Setting
Comb.: 2 on 1 / 4
on 1
Cannot copy.
Set original to ADF.
Check Paper Size
272
Causes
An original has been jammed
inside the ADF.
ID card copy could not be
performed because the tray
does not contain the valid size
paper, which are A4 or Letter
size.
Fax transmission could not be
completed because the
destination's line was busy.
Combined copying could not be
performed because the tray
does not contain the valid size
paper, which are A4, Letter, or
Legal size.
Combined copying could not be
performed because the originals
were not placed in the ADF.
The paper size set for the
document differs from the size of
the paper in the indicated tray.
Solutions
• Remove jammed originals, and then
place them again. See page 281
"Clearing Misfeeds" and page 293
"Paper Feed Problems".
• Check the originals are suitable for
scanning. See page 65 "Placing
Originals".
• Set the machine to print copies using
the A4 or Letter size paper in the
[Select Paper] setting. See page 176
"Copier Features Settings".
• Specify the A4 or Letter size paper for
the tray selected for printing copies.
See page 202 "Tray Paper Settings".
Wait for a while and send the fax again.
• Set the machine to print copies using
the A4, Letter, or Legal size paper in
the [Select Paper] setting. See
page 176 "Copier Features Settings".
• Specify the A4, Letter, or Legal size
paper for the tray selected for printing
copies. See page 202 "Tray Paper
Settings".
• Use the ADF, even when copying a
single sheet.
• If you need to use the exposure glass,
turn off combined copying in
[Duplex/Combine] under [Copier
Features], and then try again. See
page 176 "Copier Features Settings".
Press the [OK] key to begin printing, or
press the [Back] key to cancel the job.