Table of Contents
Advertisement
2. Configuring the System Using the Admin UI
2.
Click the blue triangle next to the words
control settings if needed.
3.
Select the Enable Remote Control Interface API checkbox if you want to provide developers
and/or applications with the ability to connect and control the VidyoRoom or
VidyoPanorama 600 using Remote Control APIs.
4.
Enter the username that the developers and/or applications will need to use in order to
authenticate with the system in the Username field.
5.
Enter the password that the developers and/or applications will need to use in order to
authenticate with the system in the Password field.
6.
Select the Enable HTML Remote/VidyoRemote Interface checkbox if you want to connect
and control the VidyoRoom or VidyoPanorama 600 using the HTML Remote / VidyoRemote
Interface.
7.
Enter the code that will be requested by the VidyoRemote 3 in order to connect with your
VidyoRoom or VidyoPanorama 600 system in the Pair Code field.
8.
Click Apply.
Designing the Display Layout
Display Layout
The
tab enables you to design the layout of the displays. You should carefully read
this section before you begin designing your layout.
To design the display layout:
Display Layout
1.
Click the
2.
Click Identify at the bottom of the
The Identify button indicates the display IDs and also shows the IP address of the
VidyoRoom or VidyoPanorama 600.
It's important to view the display IDs before and during the display layout design for these
reasons:
The display IDs can change if you plug the displays in and out of the back of the Vidyo
server. Therefore, before and during the display layout configuration, you should click
Identify to make sure your configuration is mapping to the displays as you intend.
You should remove any Mini DisplayPort to DVI adapters from ports where there is no
display connected. If you leave these adapters connected (even with no displays
connected to the adapters themselves), the displays will display as if they are
connected since these are active adapters.
Irrespective of which ports you connect the displays and adapters to, the display IDs
are sequential. There is no correlation between the physical ports on the back and the
virtual display IDs that you see on the screens. Therefore, if you connect a display to
Remote Control Interface
tab.
Display Layout
36
to view the remote
page.
Advertisement
Table of Contents
