Flashforge Inventor User Manual page 63

5. Click on [ Work Mode ]
6. Click on [ STA Setting
password and save.
7. Under "Connection
shown on printer LCD screen. Then, click
8. Now the Inventor is connected with FlashPrint. A status box at the lower right
corner will show the temperature of both extruders and the Platform.
9. In FlashPrint, click
"ABS" is selected under
[ More Options ].Check the box of
10. Save the file at any location, and the object will start slicing.After the object is
done slicing, it will automatically upload the gcode to the Inventor. After the gcode is
done uploading, the printer will go into a preheat phase. The Inventor will start
printing once preheating is finished.
NOTE: Printing from SD card is unavailable when WIFI is ON.
Printing with Support
If the 3D model has excessive over-hang, then support will be needed. In the
Inventor User Guide | www.flashforge.com
and choose "AP+STA
], select a working network, enter the corresponding
7-3
Mode", select Wi-Fi, and enter the
[ Print ]. A printing options screen will appear Make sure that
"Material Left." Advanced settings can be set by clicking on
"Print When Slice
mode" and save it.
[ Connect ].
Done," and hit
63
"IP Address, Port" as
[ OK ].
Slice
0086‐ 0579‐82273989