Flashforge Inventor User Manual page 46

Allows users to redo the most recent edit you have undone to your model file by the
following two methods
Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcut Ctrl+Y.
③Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
④ Select All
By the following two methods, you could select all models in the scene.(Whenmodels
are too small to be seen or out of viewing scope, please click
buttons to adjust the model.)
Method 1: Click [Edit]--[Select
Method 2: Press the shortcut Ctrl+A.
⑤ Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit]--[Duplicate]
Method 2: Press the shortcut
⑥ Delete
Select the object and delete the object through the following two methods:
Method 1: Click [Edit]--[Delete]
Method 2: Press the shortcut
⑦ Surface to Platform
After selecting the model, you can make the model surface to platform via the following
operation.
Click [Edit]--[Surface to Platform]
Inventor User Guide | www.flashforge.com
All].
Ctrl+D
Delete
into surface to platform mode(6-18)
46
[Center] and [Scale]
0086‐ 0579‐82273989